DUPPGMSRC DUPLICATE PROGRAM SOURCE TAAPGMN
The Duplicate Program and Source command allows a program and its source to be duplicated from one library to another. A typical command would be: DUPPGMSRC PGM(ABC) TOLIB(LIB2) The command would determine the source member used for program ABC and then duplicate the program to LIB2. The source used for the program would be copied to the same name source file in LIB2. A REPLACE option exists to determine what should occur if the program or source already exists. The default is REPLACE(*NO) in which case neither the program nor the source member must exist in the To library. The To source file must always exist in the To library. The user must be properly authorized to the objects to perform the duplication. For most typical error conditions, duplication will not be attempted and DUPPGMSRC will end with an appropriate escape message. Command parameters *CMD ------------------ PGM The qualified name of the program. The library value defaults to *LIBL. *CURLIB may also be used. TOLIB The library where the object will be duplicated to. TOSRCF The source file to be copied to in the To library. The default is *FROMSRCF. The source file must exist in the To library. REPLACE Whether the existing object and source will be replaced. The default is *NO meaning that neither can exist before any duplication is attempted. *YES may be specified in which case either or neither may exist. If either exists, they are removed before duplication occurs. Restrictions ------------ None. Prerequisites ------------- The following TAA Tools must be on your system: SNDCOMPMSG Send completion message SNDESCMSG Send escape message Implementation -------------- None, the tool is ready to use. Objects used by the tool ------------------------ Object Type Attribute Src member Src file ------ ---- --------- ---------- ---------- DUPPGMSRC *CMD TAAPGMN QATTCMD TAAPGMNC *PGM CLP TAAPGMNC QATTCL