UNLOAD UNLOAD A DEVICE TAATAPU
The Unload a Device command provides a simple function to ensure a device is unloaded for a *TAP device (virtual or real). If the command completes successfully and unloads the device or the device is not in a ready status (the status if already unloaded), the command completes normally. Different completion message text describes the condition. The command may be helpful when several save commands are used in a CL program and it is not known what the device condition is at the end. The tape must be initialized. A typical command would be: UNLOAD The device defaults to TAP01. UNLOAD escape messages you can monitor for ------------------------------------------ None. Escape messages from based on functions will be re-sent. UNLOAD Command parameters *CMD ------------------------- DEV The device name. The default is TAP01. Restrictions ------------ Only *TAP devices (virtual or real) are supported. The tape must be initialized. Prerequisites ------------- The following TAA Tools must be on your system: SNDCOMPMSG Send completion message SNDESCINF Send escape information Implementation -------------- None, the tool is ready to use. Objects used by the tool ------------------------ Object Type Attribute Src member Src file ------ ---- --------- ---------- ---------- UNLOAD *CMD TAATAPU QATTCMD TAATAPUC *PGM CLP TAATAPUC QATTCL