DLYJOBLOOP Delay Job Loop

DLYJOBLOOP Delay Job Loop
The Delay Job Loop command simplifies the case where you are in a loop waiting for some event to occur such as a subsystem to end. Because an unusual event might occur, good coding practice would be to place a limit on the number of times the program will wait for the event to occur. DLYJOBLOOP supports a LOOPLIMIT parameter that allows the command to send the CPF9898 escape message if the limit is reached.

DLYJOBLOOP Delay Job Loop
The Delay Job Loop command simplifies the case where you are in a loop waiting for some event to occur such as a subsystem to end. Because an unusual event might occur, good coding practice would be to place a limit on the number of times the program will wait for the event to occur. DLYJOBLOOP supports a LOOPLIMIT parameter that allows the command to send the CPF9898 escape message if the limit is reached.

For the full documentation, click here. Added to TAA Productivity tools February 1, 2005

Home Page

Last modified on March 27, 2013